Lexmark C760 - Page 49

Diagnostic information 2-13
5060-4xx
164 Motor Cyan cartridge BLDC motor mfg. unknown - go to “164 error code” on
page 2-64.
165 Motor Yellow cartridge BLDC motor mfg. unknown - go to “165 error code” on
page 2-65.
167 Motor The incorrect configuration ID. See “Web oiler fuser kit installation” on
page 4-80 to set configuration ID.
168 Motor Unknown manufacture type - perform “Motor Detect” on page 3-17. If
you do not find the problem after performing the test, call your next level
support.
169 Motor Mirror motor lock not achieved - black - go to “Printhead diagnostics”
on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
170 Motor Mirror motor lost lock - black - go to “Printhead diagnostics” on
page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
171 Motor Mirror motor lock not achieved - cyan - go to “Printhead diagnostics”
on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
172 Motor Mirror motor lost lock - cyan - go to “Printhead diagnostics” on
page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
173 Motor Mirror motor lock not achieved - magenta - go to “Printhead
diagnostics” on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
174 Motor Mirror motor lost lock - magenta - go to “Printhead diagnostics” on
page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
175 Motor Mirror motor lock not achieved - yellow - go to “Printhead diagnostics”
on page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
176 Motor Mirror motor lost lock - yellow - go to “Printhead diagnostics” on
page 3-1.
Note: Do not adjust or replace any printhead before performing checks in
“Printhead diagnostics” on page 3-1.
196 Service Thermal System The printer has detected an error in the printhead thermal drift
compensation system. Perform the “Drift Sensors” on page 3-16.
199 Service Reflash RIP The printer has detected an invalid version of the RIP code and must be
reflashed to the approved version. Contact your next level support.
Error code Action