Lexmark MS711 - Finisher (HPU) Ejector Jam Service Check

Action Yes No
Step 6
Check the drive gear assembly mechanism:
• Remove the finisher option from the printer. From the bottom of the
option, turn the lowermost drive gear clockwise. Make sure the rollers
engaged to the lowermost gear will also turn.
• Check the drive gear assembly for damage.
Is the drive gear assembly functional and free of damage?
Go to step 7. Replace the stapler
drive gear assembly.
See “Stapler drive gear
assembly removal” on
page 755.
Step 7
Reseat all connectors on the stapler controller PCBA and then POR the
machine.
Does the error remain?
Replace the stapler
controller PCBA. See
“Stapler controller
PCBA removal” on
page 749.
If the error persists,
then replace the
finisher. See “Staple,
hole punch finisher
option removal” on
page 738.
The problem is solved.
Finisher (HPU) ejector jam service check
Action Yes No
Step 1
a POR the printer.
b Reseat the installed output option on the printer.
c Clear obstructions along the paper path.
d Make sure that the sensors (pass through) are free from obstructions.
e Close the rear door properly.
Does the error remain?
Go to step 2. The problem is solved.
Step 2
Check the lower interface cable. If damaged, then replace the lower
interface cable. See “Staple, hole punch lower interface cable removal”
on page 759.
Remove the left cover. Reseat the cable J15 on the controller PCBA, then
POR the machine.
Does the error remain?
Go to step 3. The problem is solved.
Step 3
Check the auto connector end of the machine below the finisher.
Is it free of damage?
Go to step 4. Replace the upper
interface cable of the
machine under the
finisher.
4063
Diagnostic information
179