Duplex front flap removal
Warning—Potential Damage: When removing the duplex front flap, ensure that you retain the attached spring.
1 Disconnect the machine from any input options.
2 Carefully place the machine on its rear side so that the bottom of the machine is exposed, as shown in the following
image.
CAUTION—POTENTIAL INJURY: Remove all data cables and the power cord from the back of the printer
before you place it on its rear side. Otherwise, the weight of the printer will be on these cables.
3 Lower the duplex front flap to the angle shown in the following image, and gently detach it from the machine.
4063
Repair information
475
To Next Page
Loading...
