4 Remove the LVPS. See “LVPS removal” on page 511.
5 Remove the left cover. See “Left cover removal” on page 489.
6 Remove the PCBA housing. See “PCBA housing removal” on page 500.
7 Remove the main drive motor. See “Main drive motor removal” on page 497.
8 Remove the harnesses from the clamp (A).
9 Remove the three screws (B) securing the fuser drive motor to the machine.
Note: When removing the lowermost screw, the grounding plate will become detached.
10 Disconnect the cable (C) from the fuser drive motor.
4063
Repair information
495
To Next Page
Loading...
