4 Pull the shaft off the output bin, and remove.
HCOE bin removal
1 Remove the HCOE left cover. See “HCOE left cover removal” on page 589.
2 Remove the HCOE right cover. See “HCOE right cover removal” on page 588.
3 Remove the HCOE tray pinion. See “HCOE tray pinion removal” on page 598.
4 Remove the HCOE tray shaft. See “HCOE tray shaft removal” on page 614.
5 Disconnect the cable J10 from the controller board.
4063
Repair information
615
To Next Page
Loading...
