15 Disconnect the control panel ribbon cable from the control panel.
16 Remove the control panel.
Installation warning: When replacing the control panel, ensure that all cables are properly reconnected.
Control panel board (2.4‑inch tilting display) removal
Warning—Potential Damage: When replacing the control panel, control panel board, or controller board, replace
only one component at a time. Replace the required component and perform a POR before replacing a second
component. If this procedure is not followed, the printer will be rendered inoperable. Never replace both the control
panel and the controller board without a POR after installing each one or the printer will be rendered inoperable.
Never install or remove these components as a method of troubleshooting while operating in normal user mode.
See “Controller board/control panel replacement” on page 356.
4063
Repair information
434
To Next Page
Loading...
