7 Slightly move the shaft horizontally to release, and then remove it.
Warning—Potential Damage: Be careful not to lose the bushing and spacers that hold the shaft.
Installation note: To make it less difficult to re-install the E-clip, use a pair of long-nose pliers to position it onto
the shaft, and then lock it in place.
1 2
Stapler chute assembly removal
Note: This is not a FRU.
1 Remove the stapler left cover. See “Stapler left cover removal” on page 630.
2 Remove the stapler right cover. See “Stapler right cover removal” on page 624.
3 Remove the stapler diverter plunger assembly. See “Stapler diverter plunger assembly removal” on page 667.
4 Remove the stapler drive gear assembly. See “Stapler drive gear assembly removal” on page 668.
5 Remove the stapler feed roll. See “Stapler feed roll removal” on page 672.
4063
Repair information
674
To Next Page
Loading...
