OUTPUT BIN TESTS
Feed Tests
This test verifies that media can be fed to a specific output bin. No information is printed on the media.
To run the feed tests:
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Feed Tests
2 Select the output bin into which you want the paper to exit. All installed output bins appear.
3 Select one of the following:
• Single—Feeds a single page
• Continuous—Continuously feeds pages until X is pressed
Feed To All Bins
This test verifies that media can be fed to the standard bin or any installed output options. No information is printed
on the media.
To run the Feed To All Bins test:
1 From the Diagnostics menu, navigate to: OUTPUT BIN TESTS > Feed to All Bins.
The printer feeds a separate piece of media to the standard bin first, then it feeds a separate piece of media to each
output bin installed in order.
The test continuously prints the Print test pages until X is pressed.
2 Press Back to return to the OUTPUT BIN TESTS menu.
Sensor Test
This test verifies that the output bin sensors are working correctly.
To run the Output Bin Sensor Test:
1 From the Diagnostics menu, navigate to:
Output Bin Tests > Sensor Test > Standard Bin or Output Bin Tests > Sensor Test > [Output bin #]
Testing... appears while the printer is verifying the state of the sensor.
The control panel displays the current state of the sensor.
2 Manually actuate the sensor to make it toggle between empty and full or between open and closed,
depending on the sensor. If the sensor does not toggle, then the sensor is malfunctioning.
3 Press X to exit the test.
Diverter Test
This test verifies that the mailbox option’s output media diverters are working correctly. If more than one mailbox
option is installed, then this test exercises the diverters on all installed mailbox devices.
4063
Service menus
331
To Next Page
Loading...
