7 Lift the stapler carriage to access the screws securing the limit switch.
8 Remove the two screws (D) securing the limit switch.
9 Disconnect the cable J7 from the controller PCBA.
10 Route the cable off the stapler, and remove the stapler door close limit switch.
Note: Pay attention to the original routing of the cables.
Sensor (cartridge door interlock) removal
1 Remove the stapler right cover. See “Stapler right cover removal” on page 624.
2 Disconnect the cable (A) from the sensor.
4063
Repair information
627
To Next Page
Loading...
