5 Remove the two screws (B), then remove the motor.
Tamper drive belt removal
1 Remove the finisher left cover. See “Staple, hole punch left cover removal” on page 739.
2 Remove the finisher right cover. See “Staple, hole punch right cover removal” on page 741.
3 Remove the finisher top cover. See “Staple, hole punch top cover removal” on page 762.
4 Remove the tamper motor engaged to the belt. See “Tamper motor (right) removal” on page 769 or “Tamper
motor (left) removal” on page 770.
4063
Repair information
771
To Next Page
Loading...
