15 Disconnect the cable (B).
Transfer roller left arm with cable removal
1 Remove the left cover. See “Left cover removal” on page 489.
2 Remove the controller board access shield. See “Controller board access shield removal” on page 494.
3 Remove the media tray. See “Media tray removal” on page 479.
4 Remove the front door. See “Front door removal” on page 383.
5 Remove the toner cartridge.
6 Remove the imaging unit.
7 Remove the media turn guide. See “Media turn guide removal” on page 394.
8 Remove the MPF pick roller. See “MPF pick roller removal” on page 400.
9 Remove the MPF feeder lift plate. See “MPF feeder lift plate removal” on page 397.
10 Remove the media vertical guide. See “Media vertical guide removal” on page 395.
11 Remove the duplex exit diverter. See “Duplex exit diverter removal” on page 381.
12 Remove the inner guide deflector. See “Inner guide deflector removal” on page 384.
13 Remove the transfer roller. See “Transfer roller removal” on page 414.
14 Remove the media aligner roller. See “Media aligner roller removal” on page 392.
15 Remove the sensor (toner density). See “Sensor (toner density) removal” on page 408.
16 Remove the right cover. See “Right cover removal” on page 505.
4063
Repair information
410
To Next Page
Loading...
