9 Remove the three screws (C) securing the bottom part of the motor assembly.
C
10 Release the cables off their guides.
Note: Pay attention to the original routing of the cables.
11 Pull the motor assembly away from the machine.
12 Remove the mylar plate covering the sensor latches. Release the sensor latches.
13 From the other side of the frame, disconnect the sensor cable, and then remove the sensor from the frame.
Mailbox option removals
Mailbox option removal
Press the latches to release, and lift the option off the printer.
Mailbox top cover removal
Lift the top cover, and remove it from the mailbox option.
4063
Repair information
688
To Next Page
Loading...
