• “Transfer roller left arm with cable removal” on page 410
• “Transfer roller right arm removal” on page 411
• “Transfer roller removal” on page 414
• “4.3‑inch tilting display removal” on page 417
• “7‑inch tilting display removal” on page 419
• “Control panel removal (2.4‑inch screen)” on page 422
• “Control panel removal (4.3‑inch screen, 7‑inch screen)” on page 428
• “Control panel board (2.4‑inch tilting display) removal” on page 434
• “Control panel board (4.3‑inch tilting display) removal” on page 437
• “Control panel board (7‑inch tilting display) removal (MS812de)” on page 440
• “Control panel front cover removal” on page 443
• “Control panel latch removal” on page 445
• “Control panel left bezel removal” on page 446
• “Left control panel hinge removal” on page 447
• “Right control panel hinge removal” on page 450
Duplex exit diverter removal
1 Remove the left cover. See “Left cover removal” on page 489.
2 Remove the controller board access shield. See “Controller board access shield removal” on page 494.
3 Remove the media tray. See “Media tray removal” on page 479.
4 Remove the MPF tray. See “MPF tray removal” on page 404.
5 Remove the front door. See “Front door removal” on page 383.
6 Remove the toner cartridge.
7 Remove the imaging unit.
8 Remove the MPF feeder lift plate. See “MPF feeder lift plate removal” on page 397.
9 Remove the media turn guide. See “Media turn guide removal” on page 394.
10 Remove the media vertical guide. See “Media vertical guide removal” on page 395.
4063
Repair information
381
To Next Page
Loading...
