200 paper jam messages
Error code Description Action
200.01 Media remains on the sensor (input) during
the warm‑up sequence.
Go to “Sensor (input) static jam service check” on page 70.
200.02 Media reached the sensor (input) sooner
than the specified time. The wrong config ID
causes the engine to assume a 550 paper
path on a 250 model.
Go to “Sensor (input) early arriving jam service check” on
page 71.
200.03 Media is late reaching the sensor (input)
within the specified time.
Go to “Sensor (input) never‑ or late‑arriving jam service check”
on page 72.
200.05 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = MPF tray)
Go to “Sensor (input) late-leaving or did-not-clear jam service
check” on page 74.
200.07 Media reached the sensor (input) but did not
clear it within the specified time.
Go to “Sensor (input) late-leaving or did-not-clear jam service
check” on page 74.
200.08 Media is late reaching the sensor (input)
within the specified time.
Go to “Sensor (input) never‑ or late‑arriving jam service check”
on page 72.
200.09 The proper main motor feedback to start
laser servo was not received.
Go to “Main drive motor control jam service check” on
page 75.
200.10 Printhead motor was not locked when page
reached the sensor (input).
Go to “Printhead motor control jam service check” on
page 76.
200.11 Printhead motor fell out of lock after the
page reached the sensor (input).
Go to “Printhead motor control jam service check” on
page 76.
200.12 Printhead was not ready for the page when
the sensor (input) was reached.
Go to “Printhead motor control jam service check” on
page 76.
200.13 The page at the sensor (input) is not the next
page to be imaged.
Go to “Sensor (input) miscellaneous jam 1 service check” on
page 76.
200.14 Proper main motor feedback to start laser
servo was not received.
Go to “Main drive motor control jam service check” on
page 75.
200.15 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 1)
Go to “Sensor (input) late-leaving or did-not-clear jam service
check” on page 74.
200.16 Main drive motor stalled. Go to “Main drive motor control jam service check” on
page 75
.
200.17 Fuser motor stalled. Go to “Fuser drive motor control jam service check” on
page 76.
200.19 Paper never reached the sensor (input), but
it was successfully picked from the source.
Go to “Sensor (input) miscellaneous jam 1 service check” on
page 76.
200.25 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 2)
Go to “Sensor (input) late-leaving or did-not-clear jam service
check” on page 74.
200.32 Detected sensor (control panel interlock)
bounce.
Go to “Sensor (input) miscellaneous jam 2 service check” on
page 77.
4063
Diagnostic information
69
To Next Page
Loading...
