Error code Description Action
200.33 Printhead was not ready for page when
sensor (input) was reached.
Go to “Printhead motor control jam service check” on
page 76.
200.34 Short media detected. Go to “Sensor (input) miscellaneous jam 3 service check” on
page 77.
200.35 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 3)
Go to “Sensor (input) late-leaving or did-not-clear jam service
check” on page 74.
200.45 Media reached the sensor (input), but did not
clear it within the specified time. (Media
source = Tray 4)
Go to “Sensor (input) late-leaving or did-not-clear jam service
check” on page 74.
Sensor (input) static jam service check
Action Yes No
Step 1
Check the media path for partially fed or jammed media.
Is the media path free from partially fed or jammed media?
Go to step 2. Remove any pre-
staged or jammed
media.
Step 2
Check the sensor (input) for proper operation.
a Enter the diagnostic mode.
b Select Base sensor test.
c Observe the line item input.
Does the display on the operator panel change every time the sensing
area of the above sensor is interrupted or blocked?
Go to step 4.Go to step 3.
Step 3
Check the above sensor for proper connection.
Is the above sensor connected properly?
Replace the Sensor
(input). See “Sensor
(input) removal” on
page 407.
Go to step 4.
Reseat the connection.
Go to step 4.
Step 4
Perform a print test.
Does the problem remain?
Contact the next
highest level of tech
support.
Problem resolved.
4063
Diagnostic information
70
To Next Page
Loading...
