4 Remove the two screws (C) securing the diverter plunger and cam.
C
5 Remove the cam first, and then remove the plunger.
Installation note: Make sure that the pin (D) is inserted into the center hole on the diverter cam. The C-shaped
slot on the cam must be engaged with the locating pin on the plunger.
D
Stapler drive gear assembly removal
1 Remove the stapler left cover. See “Stapler left cover removal” on page 630.
2 Remove the stapler diverter plunger assembly. See “Stapler diverter plunger assembly removal” on page 667.
4063
Repair information
668
To Next Page
Loading...
