12 Remove the mylar plate (D) covering the sensor latches. Release the sensor latches.
13 From the other side of the frame, disconnect the sensor cable, and then remove the sensor from the frame.
Sensor (stapler diverter plunger HP) removal
1 Remove the stapler left cover. See “Stapler left cover removal” on page 630.
2 Remove the stapler right cover. See “Stapler right cover removal” on page 624.
3 Remove the stapler diverter plunger assembly. See “Stapler diverter plunger assembly removal” on page 667.
4 Remove the stapler drive gear assembly. See “Stapler drive gear assembly removal” on page 668.
5 Remove the stapler feed roll. See “Stapler feed roll removal” on page 672.
6 Remove the stapler chute assembly. See “Stapler chute assembly removal” on page 674.
4063
Repair information
686
To Next Page
Loading...
