If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and then install
a genuine Lexmark supply or part.
Note: For a list of supported supplies, see the “Ordering supplies” section of the User's Guide or visit
www.lexmark.com.
Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
to confirm.
• Delete fonts, macros, and other data stored in the flash memory.
• Upgrade to a larger capacity flash memory card.
Note: Downloaded fonts and macros that are not previously stored in the flash memory are deleted.
PPDS font error [50]
Try one or more of the following:
• From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
to confirm.
• If the printer cannot find the requested font, then from the printer control panel, navigate to:
PPDS menu > Best Fit > On
The printer will find a similar font and reformat the affected text.
• Cancel the current print job.
Paper changes needed
Try one or more of the following:
• Select Use current supplies on the printer control panel to clear the message and continue printing.
For non-touch-screen printer models, press
to confirm.
• Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
• Select Continue to clear the message. For non-touch-screen printer models, press to confirm.
The printer discards any data received through the parallel port.
• Select Reset active bin to reset the bin for a linked set of bins.
4063
Diagnostic information
223
To Next Page
Loading...
