Lexmark MS711 - Staple, Hole Punch Latch Removal; Stapler Controller PCBA Removal; Staple, Hole Punch Left Cover Removal

Staple, hole punch latch removal
1 Remove the finisher left cover or finisher right cover. See “Staple, hole punch left cover removal” on page 739 or
“Staple, hole punch right cover removal” on page 741.
2 Pull the latch off the finisher.
Note: The latch on the right side of the finisher can also be removed by the same manner.
Stapler controller PCBA removal
1 Remove the finisher left cover. See “Staple, hole punch left cover removal” on page 739.
2 Remove the three screws (A) from the controller PCBA.
3 Disconnect all connectors, and then remove the controller PCBA.
4063
Repair information
749