Staple, hole punch tray link tension spring removal
1 Remove the finisher left cover. See “Staple, hole punch left cover removal” on page 739.
2 Remove the finisher right cover. See “Staple, hole punch right cover removal” on page 741.
3 On the left side of the finisher, unhook the tension spring (A), and then remove.
4 On the right side of the finisher, unhook the tension spring (B), and then remove.
Staple, hole punch tray link removal
1 Remove the finisher left cover. See “Staple, hole punch left cover removal” on page 739.
2 Remove the finisher right cover. See “Staple, hole punch right cover removal” on page 741.
3 Remove the stapler controller PCBA. See “Stapler controller PCBA removal” on page 749.
4063
Repair information
774
To Next Page
Loading...
