HCOE upper interface cable removal
1 Remove the HCOE sensor cover. See “HCOE sensor cover removal” on page 586.
2 Remove the HCOE left cover. See “HCOE left cover removal” on page 589.
3 Disconnect the upper interface cable from the controller PCBA.
4 Crimp both connector pins using pliers to make them fit through the pin holes. Push the connector out of its slot.
5 Remove the upper interface cable.
HCOE option latch removal
1 Remove the HCOE left cover or HCOE right cover. See “HCOE left cover removal” on page 589 or “HCOE right cover
removal” on page 588.
2 Pull the latches off the mailbox, and then remove.
Note: The latch on the opposite side can be removed using the same method shown.
4063
Repair information
594
To Next Page
Loading...
