• “Pick roller assembly removal” on page 482
• “Right frame extension” on page 483
• “Sensor (duplex path) removal” on page 484
• “Sensor (tray 1 media out) removal” on page 485
• “Separator roller assembly removal” on page 487
Duplex removal
1 Remove the top cover. See “Top cover removal” on page 466.
2 Remove the left cover. See “Left cover removal” on page 489.
3 Remove the rear door. See “Rear door removal” on page 456.
4 Remove the rear lower cover. See “Rear lower cover removal” on page 454.
5 Remove the PCBA housing. See “PCBA housing removal” on page 500.
6 Remove the fuser access door. See “Fuser access door removal” on page 461.
7 Remove the duplex motor. See “Duplex motor removal” on page 457.
8 Remove the media tray. See “Media tray removal” on page 479.
9 Remove the pick roller assembly. See “Pick roller assembly removal” on page 482.
10 Remove the media feeder. See “Media feeder removal” on page 498.
11 Remove the two screws (A) securing the duplex to the machine.
12 Gently lay the printer on its side.
4063
Repair information
473
To Next Page
Loading...
