Error
code
Description Action
53 Unformatted flash Try one or more of the following:
• From the printer control panel, press
Continue to stop the defragmentation and
continue printing.
• Format the flash memory device.
Note: If the error message remains, then
the flash memory device may be defective
and need to be replaced.
54 Network error—communication failure between the controller
board and the network port
Try one or more of the following:
• From the printer control panel, press
Continue to confirm.
• Unplug the router, then wait for 30
seconds, and then plug it back again.
• POR the machine.
• Update the network firmware in the printer
or print server.
55 Unsupported option card detected
1 Turn off the printer.
2 Unplug the power cord from the electrical
outlet.
3 Remove the unsupported option card
from the printer controller board, and
then replace it with a supported card.
4 Re‑connect the power cord, and then turn
the machine on.
56 USB port disabled Do either of the following:
• From the printer control panel, select
Continue to clear the message and
continue printing without using the
specified bin/tray.
• Select Reset active bin to reset the bin for
a linked set of bins.
59 Incompatible output bin/tray Do either of the following:
• Remove the specified bin.
• From the printer control panel, press
Continue to clear the message and
continue printing without using the
specified bin/tray.
80 Maintenance kit—end of life Install maintenance kit.
80 Maintenance kit—late warning Install maintenance kit.
80 Maintenance kit—low Install maintenance kit.
80 Maintenance kit—nearly low Maintenance kit is near the end of its life.
81 Roller kit—end of life Install a roller kit.
4063
Diagnostic information
234
To Next Page
Loading...
