6 Remove the output bin sensor cover. See “Output bin sensor cover removal” on page 463.
7 Remove the sensor (standard bin full) with actuator. See “Sensor (standard bin full) removal” on page 466.
8 Remove the standard bin cover. See “Standard bin cover removal” on page 467.
9 Remove the control panel. See “Control panel removal (2.4‑inch screen)” on page 422or “Control panel removal
(4.3‑inch screen, 7‑inch screen)” on page 428.
10 Disconnect the right recoil spring.
11 Remove the controller board access shield. See “Controller board access shield removal” on page 494.
12 Disconnect the control panel ribbon cable (A) from the controller board.
4063
Repair information
451
To Next Page
Loading...
