5 Release the latches (A) securing the sensors.
6 Remove the stapler output bin LED. See “Stapler output bin LED removal” on page 772.
7 Remove the left and right tamper motors. See “Tamper motor (left) removal” on page 770 and “Tamper motor
(right) removal” on page 769.
8 Remove the tamper drive belts. See “Tamper drive belt removal” on page 771.
9 Remove the two screws (B) from the tamper assembly.
10 Pull away the tamper assembly, and remove.
Installation note: Make sure the tab (C) is correctly inserted into its designated slot.
4063
Repair information
768
To Next Page
Loading...
