General operation procedure
Lorrca Maxsis User Manual Page 133
Version 5.04 MRN-231-EN
Always check whether CUP and BOB are clean and dry before entering a blood sample. When
CUP and/or BOB are dirty or some cleaning fluid is left, the measurement results may be
influenced.
Insert 600-900 µl of the blood suspension in the gap between BOB and CUP using a pipette
(see above Figure.). Press Aspirate and check if the suspension level is high enough and
without air bubbles. Capillary forces usually keep the suspension within the gap. However, if
capillary forces are insufficient, more of test suspension is required to fill the whole geometry
(including the bottom). After inserting more blood suspension, aspirate again.
Close the hood.
Press <OK>
7.7.3. Adjust temperature RBC aggregation screen
To Next Page
Loading...