Lorrca MaxSis - General Options; Elongation; Deformability Curve Parameters

Lorrca MaxSis Program
Page 60 Lorrca Maxsis User Manual
Version 5.04 MRN-231-EN
6.4.2. General options
Settings parameter Description Range
Fill empty speed (rps) Cup revolution speed (revolutions per
second) used at the moment of inserting or
removing the test suspension.
[0.1, 10] rps
Shear stress for camera
adjustment (Pa)
Shear stress applied during camera
adjustment (diaphragm).
[0, 100] Pa
Bob temperature (°C) Desired bob (and hence, suspension)
temperature in degrees Centigrade.
[20, 45] °C
Auto start if temp. is stable
within (°C)
If temperature is within ± 0.2 °C, the
measurement starts after the value given
at parameter ... for at least (see next)
[0.1, 10] °C
… for at least (s) Time to automatic start
[5, 300] s
6.4.3. Elongation
6.4.3.1. Deformability curve Parameters
Settings parameter Description
Logarithmic shear stress
axis
Checkbox Turns this option on/off