Installation
Lorrca Maxsis User Manual Page 41
Version 5.04 MRN-231-EN
5.3.2. Main power connection
The instrument is delivered with an 10A/230V rated Euro plug lead 10A with locking system for IEC
inlets. Do not replace with inadequately rated cords. Also delivered is an extension socket.
For a 110V connection an IEC Lock PC 1063 120V US power cord can be delivered.
The pO2scan comes along with an additional power strip to make sure both Lorrca + pO2scan can
be powered. The power strip is equipped with a safety switch, enabling the user to power down the
entire Lorrca + pO2scan setup in case of calamities. The pO2scan draws power from a standard
laptop charging power supply.
5.3.3. Unpacking / Setting Up
1. When setting up, take a minimum table space of 700x900 mm in account.
Check for damage during transport.
To Next Page
Loading...