Lorrca MaxSis - Error Messages

Trouble shooting
Page 152 Lorrca Maxsis User Manual
Version 5.04 MRN-231-EN
9.1. Error messages
Error Description/Check Remedy
Error 1
Error in ambient temperature measuring
circuit. NTC transmits values that are
rejected (<10 °C or >45 °C).
 Exit software and switch off the
LoRRca.
 Check communication cables to
computer.
 Switch on the LoRRca and start the
software.
Error 7
Error in conductivity measuring circuit.
Measured calibration factor too high or
too low. This happens during initiation
and is not depending on attached
measuring cell or conductivity NTC.
 Exit software and switch off the
LoRRca.
 Check communication cables to
computer.
 Switch on the LoRRca and start the
software.
Error 8
Home sensor is not sensed during
initiation of the servomotor.
 Exit software and switch off the
LoRRca.
 Check communication cables to
computer.
 Switch on the LoRRca and start the
software.
Error 9
BOB heating wrong. Heating takes too
much time to reach temperatures above
25 °C.
 Exit software and switch off the
LoRRca.
 Check communication cables to
computer.
 Switch on the LoRRca and start the
software.
 Temperature BOB > 44
0
C
Error
25
I2C error. The I2C communication is not
handled well.
 Exit software and switch off the
LoRRca.
 Check communication cables to
computer.
 Switch on the LoRRca and start the
software.
Error
26
Error in braking system. During initiation
the brake did not activate (Servo is
activated and there are encoder pulses)
 Exit software and switch off the
LoRRca.
 Check communication cables to
computer.
 Switch on the LoRRca and start the
software.