Lorrca MaxSis - Stability Test Parameters; Aggregation; Disaggregation Options

Lorrca MaxSis Program
Page 62 Lorrca Maxsis User Manual
Version 5.04 MRN-231-EN
6.4.3.3. Stability test parameters
Settings parameter Description Range
Stability shear stress
(Pa)
Shear stress used during the stability test (Pa)
[0.01, 100]
Pa
Measurement duration
(s)
Duration of stability test.
[1, 100000] s
Determine
deformability every (s)
Time that elapses before performing another
deformability measurement (diffraction pattern
analysis).
[1, 3600] s
Valid determinations
per measuring point
Prescribes the number of subsequent EI
determinations (each from a newly acquired diffraction
image) to find the average EI (and SD) per
deformability measurement.
[1, 200]
6.4.4. Aggregation
This section gives a short description for all Settings parameters that influence the way
aggregation measurements are performed.
Settings parameter Description
Auto store
measurements
Checkbox Turns this option on/off
6.4.4.1. Disaggregation options
Settings parameter Description Range
Disaggregation shear
rate (1/s)
This disaggregation shear rate and time apply
throughout the aggregation measurement
procedure:
1. Before measuring the syllectogram,
2. For intermediate disaggregation during the
iteration procedure.
3. Just before applying the "Low shear rate" during
the FSAR measurement.
[5, 2500] /s
disaggregation time (s)
[0, 3600] s