CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 227
Revision 28
05-20-50
Table 207. Inspection 6 − Baggage Compartment (Area 6) (Cont.)
Registration No. Serial No. Helicopter Total Hours
Model InitialRMM SectionRequirement
Electrical
900 Inspect generator control units for condition, correct installation, and
security of electrical connections.
96−00−00
900 Inspect electrical load center for correct installation, security, and
correct installation of electrical wiring and connections.
96−00−00
900 Inspect strobe power supply for condition and security. 96−40−00
900 Inspect area electrical wiring and electrical component installation for
condition, support, and security of hardware.
98−00−00
If optional aft battery installation is installed:
900 Inspect battery installation (Aft Installation):
battery case and cover for condition and damage, installation
hardware for correct installation
vent tubes for condition and correct installation
power connection and temperature sensor connection for condition
and security.
96−10−00
900 Inspect external power box or external power relay for condition,
correct installation, and security of wiring and electrical connections.
96−00−00
Touch−up all damaged paint as necessary.
Helicopter must not be moved or flown unless cockpit floor, cabin floor and bag-
gage floor panels are securely installed. These are stressed panels.
CAUTION
Install all floor and access panels, covers and trim panels removed or opened for inspection. Do a
check of all loose equipment for correct stowage.
Airframe Segmented Inspection Program Inspection 6 Certification
I certify that this aircraft has been inspected in accordance with the Airframe Segmented Inspection Program
Inspection 6 inspection requirements and is determined to be in an airworthy condition.
Signature
Rating Type or Certification No.
Date
To Next Page
Loading...
