MG MG6 Series 2011 - Sensor - Camshaft Position (CMP) - VCT; Sensor - Inlet Camshaft Position (CMP) - VCT

Engine
EngineFuel&ManagementSystem
Sensor-camshaftposition(CMP)-VCT
Remove
1.Disconnectbatteryearthlead.
2.Remove3boltsandsparkplugcover.
3.DisconnectthemultiplugfromCMPsensor .
4.RemoveboltsecuringCMPsensor,removeCMPsensor
anddiscardO-ring.
Ret
1.CleanCMPsensorandcomponentmatingfaces.
2.FitO-ringsealtoCMPsensor,tboltandtightento
8Nm.
3.ConnectCMPsensormultiplug.
4.Fitsparkplugcover,tightenboltsto7–10Nm.
5.Connectbatteryearthlead.
Sensor-inletcamshaftposition(CMP)-VCT
Remove
1.Disconnectbatteryearthlead.
2.DisconnectCMPsensormultiplug.(Exhaust
CMPsensorillustrated).
3.RemoveboltsecuringCMPsensortocylinderheadand
removeCMPsensor.Removeanddiscardgasket.
Ret
1.CMPOCMP
2.FitCMPsensorstocylinderheadandsecurewithbolt
to8Nm
3.ConnectCMPsensormultiplug.
4.Connectbatteryearthlead.
Version2.0318