MG MG6 Series 2011 - Service Procedures; Oil Seal-Gear Change Rod

T ransmission-MT
T ransmission
ServiceProcedures
OilSeal–GearChangeRod
Remove
1.Removebatterycarrier.
Battery Battery
Battery
Carrier Carrier
Carrier
Bracket–Remove Bracket–Remove
Bracket–Remove
2.Ensureneutralisselected.
3.Notettedpositionandcarefullydisconnectgear
changecableballjointfromshiftandselectorlevers.
4.Remove2boltssecuringselectorleverbracketto
transmissionandremovebracket.
5.Withassistance,supportgearselectorlever,remove
rollpinsecuringgearselectorleverandremovelever.
6.Removeanddiscardgearchangeoilseal.
Ret
1.Cleangearchangeoilsealrecess,gearchangecover
andtransmissionmatingfaces.
2.UsingT24016tnewsealtogearchangecover
ensuringsteppedportionofsealfacesoutwards.
3.Fitgearshiftleverandsecurewithnewrollpin.
4.Fitselectorleverbrackettotransmissioncasing,t
boltsandtightento22–30Nm.
5.Connectcableballjointstoshiftandselectorlevers.
6.Checkgearchangequality,ifgearchangeispoorwith
highfrictionalloads,thisindicatesincorrectassembly.
Removeassemblyandrepeatretinstructions.
7.Fitbatterycover.
Battery Battery
Battery
Carrier Carrier
Carrier
Bracket–Refit Bracket–Refit
Bracket–Refit
Version2.0
411