MG MG6 Series 2011 - Service Procedures; Bumper Assembly - Front

ExteriorFitting
Bumpers,FasciasandGrille
ServiceProcedures
BumperAssembly-Front
Remove
1.Disconnectbatteryearthlead.
2.Remove6screwssecuringfrontgrilletobonnetlocking
platform.
3.Removeundertray.
Undertray Undertray
Undertray
- -
-
assembly-Remove. assembly-Remove.
assembly-Remove.
4.Remove2selftappingscrewssecuringfrontbumper
tofrontwheelarch.
5.Remove2self-tappingscrewsfrombumperto(1per
side).
6.Releaseambientairtemperaturesensorfrombumper.
7.Withassistance,carefullyliftpullingoutwardsoneach
sideofbumpertoclearsidemountings.
8.Disconnectfoglampmultiplugs.
9.DisconnectPDCsensormultiplugs(iftted).
10.Removethefrontbumperandremove4screws
securingfoglamptobumper.
11.Remove6screwsandremovethehighbracket.
12.Release15clipsandremovebumpergrille.
13.Release14clipsandremovelowergrille.
14.Release2clipsandremovethebezeloffrontfoglamps.
Ret
1.Fiteachbezeloffoglamps,highandlowergrille,and
secureclips.
2.Fitfoglampsandsecurewithscrews.
3.Withassistancepositionbumpertovehicle,connect
foglampmultiplugsandsecureambienttemperature
sensorwithclip.
4.ConnectPDCsensormultiplugs(iftted).
5.Slidebumperintopositionandengagebumperside
mountings.
6.Fitandtighten6screwssecuringbumpertobonnet
lockingplatformto7–10Nm.
7.Fitandtightenscrewssecuringbumpertowheelarch.
8.Positionandretundertray.
Undertray Undertray
Undertray
- -
-
assembly-Refit. assembly-Refit.
assembly-Refit.
9.Connectbatteryearthlead.
Version2.0702