MG MG6 Series 2011 - Service Procedures; RH Shaft & both Joints

Driveline/Axle
DriveAxle
ServiceProcedures
RHShaft&BothJoints
Remove
1.Raisethevehicleonalift.
2.Removefrontwheelarchliner.
Liner Liner
Liner
- -
-
front front
front
wheel wheel
wheel
arch arch
arch
- -
-
front front
front
3.Priselockingdevicefromnut.Withanassistantpressing
brakepedal,removeanddiscarddriveshaftnut.
4.Removenutfromtrackrodend,tanM10nuttoball
pin,ushwithendofpin.
5.BreaktaperjointusingtoolT38008andreleaseend
fromtrackrod.
6.Removenutfromballpin.
7.Removenutsecuringlinktoantirollbarandrelease
link.
8.Removenutandboltsecuringhubtolowerarm.
9.UsingT32011releaselowerarmballjoint.
10.Takecarenottodamagelowerballjointrubbergaiter.
11.FitlowerballjointbootprotectorT32003.
12.Pullhuboutwardtoreleasedriveshaftfromhub.
13.Remove3boltssecuringdriveshaftcarrierbracketto
cylinderblock.
14.Releasedriveshaftfromdifferentialandremove.
15.Removedustshield.
16.Removeanddiscarddriveshaftcirclip.
Ret
1.Fitdustshield.
2.Fitnewdriveshaftcirclip.
3.Cleanendsofdriveshaftandlocationsinhuband
differential.
4.Fitdriveshafttodifferentialandpushfullyhome.
5.Cleanmatingfaceofdriveshaftsupportbracketand
cylinderblock.
6.Fitboltssecuringdriveshaftcarrierbrackettocylinder
blockandtightento
19–25Nm.
7.RemovelowerarmballjointbootprotectorT32003.
8.Pullhuboutwards,engagedriveshafttohubandt
hubtolowerballjoint.
9.Fitnutandboltsecuringhubtolowerarmandtighten
to40–50Nm.
Version2.0646