Patient Information
8-2
To exit the "Patient Info" screen
z In the [Patient Info] screen, click [OK] or press the <Info> key again to save the
entered patient information and exit the screen.
z Click [Cancel] or press <Esc> to exit the screen without saving any of the entered
patient data.
z After entering the patient information, press <Probe> key to exit Patient Info
screen and enter Probe & Exam screen.
To start a new patient exam, press <Info> key to open the Patient Info screen. See the
figure below:
To input patient information:
Open the Patient Info screen. Place the cursor into the specific box, the field box is
highlighted and a flashing cursor appears. Information can be entered or selected from
the options.
You can also change the cursor position by <Tab>, <Enter> or up/down controls.
Information includes:
1. General information
Patient ID
Once you enter the ID and confirm it, you are not allowed to change it. There are 2
ways to generate the patient ID: auto generate ID and enter the ID manually. And “\”
is not permitted.
h Auto generated ID
Select "Auto generated ID" through the path: [Setup] → [System Preset] →
[General].
The system will automatically populate the (patient) ID field with a unique
time-stamp identification code. The auto generated ID can be edited manually.
1
2
4
3
To Next Page
Loading...
Need help?
General
