Parameter Setup
17-11
17.10 Network Preset
Please refer to the DICOM chapter and “Network Storage” section for details about
network settings.
17.11 Manage Settings
The [Manage Settings] page is used to import or export the setup data or restore factory
setup data.
17.11.1 Exporting Setup Data
This function is used to write all setup data of the system into a disk for back-up. The
format of the data file is .DTA.
The procedures are described as follows:
1 Select some or all items in the [Export] field on the left side of the [Manage Settings]
screen.
2 Click [Export] to open the [Export Data] screen.
3 Select the path to save the data.
4 Select the exported file and type as DTA.
5 Click [OK].
17.11.2 Importing Setup Data
This function is used to import the existing setup data to the setup data memory of the
system. The system will reset and operate according to the setup preferences that were
imported.
The procedures are described as follows:
1 Select an item in the [Import] field on the right side of the [Manage Settings] screen.
2 Click [Import] to open the [Import Data] screen.
3 Select the path to save the data.
4 Select the imported file and type as DTA.
5 Click [OK].
6 To restore the factory setup data, click [Restore Factory] on the right side of the screen.
You can use [Export], [Import All], or [Restore Factory] at the bottom of the screen to
export, import all setup data of the system or restore all factory setup data of the system.
The operating methods are the same as those mentioned above.
17.12 Maintenance
The [Maintenance] item is designed for you to update the system software or other
special functions. If you require these functions, please contact Mindray Customer
Service Department or sales representative.
To Next Page
Loading...
Need help?
General
