367
Kaleido-X
User’s Manual
To configure layout elements for dynamic text and tally reporting
1Click the Layouts tab, and then open the layout you wish to configure.
2In the Tools pane, select one of the logical sources you previously configured (see
“Assigning Kayenne Tallies, Input Names, and Output Names to Logical Sources” above)
from the filtered Channels/Sources list, and then drag it onto the appropriate monitor.
3Repeat step 2 until you have assigned all the sources you wish to monitor to the
appropriate monitors in your layout.
4 Click the first UMD whose dynamic text and tally reporting behavior you with to set,
after unlocking the composite monitor that contains it if applicable (see
Unlocking a
Composite Monitor, on page 260).
5In the Properties pane, click the Left tally source level box, and then select the alarm
level you wish to monitor.
Alarm level selection for the left tally in a UMD
6Click the Right tally source level box, and then select the appropriate alarm level, if
applicable.
7Click the Text label level box, and then select the text level you wish to monitor.
To Next Page
Loading...
