Moons' MBDV Series - Precautions During Trial Operation; Certified Specifications

9
Rev. 2.0
07/27/2023
MBDV Hardware Manual
1.5.4 Precautions during trial operation
◆
Do not directly touch the rotating motor shaft with your hands
◆
In the rst test run, rst separate the coupling or belt of the mechanical equipment, so that the motor
is in a no-load state
◆
Incorrect parameters will cause abnormal operation under load
◆
The temperature of the drive radiator, motor
, and external regeneration resistor will rise during
operation, please avoid touching
◆
Before the machine starts running, please conrm whether the emergency stop device can be
activated at any time
◆
Use servo motors with brakes on vertical loads to avoid equipment falling during alarm, failure,
power failure
1.6 Certied Specications
MBDV series low voltage servo products are designed to meet the following standards.
Drive Motor
Europe
EMC
Directive
EN 61800-3
EN 55011
EN 55014-1
EN 55014-2
EN 6100-3-2
EN 6100-3-3
LVD EN 61800-5-1
EN 60034-1
EN 60034-5
Functional
Safety(STO)
UL61800-5-2(SIL2)
IEC61508
ISO13849-1(PL d)
UL Standard UL 61800-5-1
UL 1004-1
UL 1004-6
CSA Standard C22.2 No.274-13 CSA C22.2 No.100