MR ETOS IM - Page 260

7 Operation
Maschinenfabrik Reinhausen GmbH 2019260 5163667/06 ENETOS
®
IM
Transmission procedure
You can use this parameter to set the transmission procedure. You can se-
lect the following options:
▪ Unbalanced transmission
▪ Balanced transmission
To set the transmission procedure, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Transmission pro-
cedure.
2. Select transmission procedure.
3. Press the Accept button to save the modified parameter.
Octet number of link address
You can use this parameter to set how many octets are provided for the link
address.
To set the octet number of the link address, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Octet number of link
address.
2. Set octet number of link address.
3. Press the Accept button to save the modified parameter.
Link address
You can use this parameter to set the link address.
To set the link address, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Link address.
2. Set link address.
3. Press the Accept button to save the modified parameter.
Octet number of ASDU address
You can use this parameter to set how many octets are provided for the
ASDU address.
To set the octet number of the ASDU address, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Octet number of
ASDU address.
2. Set octet number of ASDU address.
3. Press the Accept button to save the modified parameter.
ASDU address
You can use this parameter to set the address of the ASDU.