MR ETOS IM - Page 261

7 Operation
Maschinenfabrik Reinhausen GmbH 2019 2615163667/06 EN ETOS
®
IM
To set the ASDU address, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > ASDU address.
2. Set ASDU address.
3. Press the Accept button to save the modified parameter.
Octet number of information object address
You can use this parameter to set how many octets are provided for the ad-
dress of the information object.
To set the octet number of the information object address, proceed as fol-
lows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Octet number of in-
formation object address.
2. Set octet number of information object address.
3. Press the Accept button to save the modified parameter.
Octet number of cause of transmission
You can use this parameter to set how many octets are provided for the
cause of transmission.
To set the octet number of the cause of transmission, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Octet number of
cause of transmission.
2. Set octet number of cause of transmission.
3. Press the Accept button to save the modified parameter.
Number of data bits
You can use this parameter to set the number of databits.
To set the number of data bits, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Number of data bits.
2. Set number of data bits.
3. Press the Accept button to save the modified parameter.
Parity
You can use this parameter to set the parity. You can select the following
options:
▪ None
▪ Even
▪ Odd
To set the parity, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-101 > Parity.
2. Select parity.