Protocol
code
Display message Cause
022 PROGRAM ERROR MAKE
DEFAULT RESET
CODE: 22
Error in the program flow
Elimination
• Perform a default reset
Pos: 79.18 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/23_E RROR_UART-A(B)_RESE T_THE_PRINTER @ 2\mod_126 5618506397_912.doc @ 11326 @
Protocol
code
Display message Cause
023 UART-A ERROR RESET THE
PRINTER
CODE: 23
PC was powered on or off
Elimination
• Turn on the PC before turning
on the printer
• Restart the printer
Pos: 79.19 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/24_D ISPLAY_TIMEOUT_RESE T_THE_PRINTER @ 2\mod_126 5618599463_912.doc @ 11329 @
Protocol
code
Display message Cause
024 DISPLAY TIMEOUT RESET THE
PRINTER
CODE: 24
Error of display controller
Elimination
• Restart the printer
Pos: 79.20 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/25_C HECK_CARTRIDGE(s) _HIT_OK_TO_CONTINUE @ 2\mod_126 5618631465_912.doc @ 11332 @
Protocol
code
Display message Cause
025 CHECK CARTRIDGE(S) START TO
CONTINUE
CODE: 25
Cartridge no. # of print unit no.
# is not inserted
Elimination
• Insert missing cartridge(s) • If a cartridge is inserted:
Turn off the machine and
then take out the cartridge
and clean the contacts on the
cartridge and the contacts in
the pen board. Insert the
cartridge again.
Pos: 79.21 /Bedienungsan leitungen/Gerät e spezifisch/Dr ucker/Error Messages/ 26_ADDRESS_TOO_LONG_ HEAD_ONLY @ 2\mod_126561867252 9_912.doc @ 11335 @
To Next Page
Loading...
