Neopost AS-710 - Page 116

116 User Manual Version 3.1
Protocol
code
Display message Cause
033 MACRO TOO HIGH REDUCE TO x
INCHES
CODE: 33
A macro sent from the PC does
not fit into the print area
Elimination
• Reduce the height of the
macro to # inches
Pos: 79.29 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/34_F ONT_ERROR _!!_LOAD_FLA SH_FONTS! @ 2\mod_12656 19140985_912.doc @ 11362 @
Protocol
code
Display message Cause
034 FONT ERROR LOAD FLASH
FONTS!
CODE: 34
Error in the flash prom
Elimination
• Call service
Pos: 79.30 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/35b_P AP._LENGTH_TOO_S MALL_SHUTTLE_HEAD_ONLY @ 2\mod_1265619177500_91 2.doc @ 11365 @
Protocol
code
Display message Cause
035 PAP.LENGTH TOO SMALL MIN.
VALUE:
CODE: 35
Wrong paper length during
paper size measurement or at
job start from PC
Elimination
• Check if the paper size is
within the printer
specifications
• Check if the correct paper size
is sent from the PC.
• Check if the paper sensor
triggers before the rear edge
of the paper
Pos: 79.31 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/47_E RROR_SMC1_RESET_THE_ PRINTER @ 2\mod_12656198644 79_912.doc @ 11401 @
Protocol
code
Display message Cause
047 ERROR SMC1 RESET THE
PRINTER!
CODE: 47
ERROR in the SMC1 module
Elimination
• Reset the printer • Call service
Pos: 79.32 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/48_E RROR_SCC_RESET_THE_P RINTER @ 2\mod_126561993637 1_912.doc @ 11405 @
Protocol
code
Display message Cause
048 ERROR SCC RESET THE PRINTER!
CODE: 48
ERROR in the SCC module
Elimination
• Reset the printer • Call service
Pos: 79.33 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Error Messages/49b_S AFTEY_COVER_OPEN @ 2\ mod_1265620428158_912. doc @ 11411 @