S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Configure Switching User Manual136
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Discover or Change the Switch IP
Address on page 12.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is
password.
The System Information page displays.
5. Select Switching> VLAN >
Advanced > Voice VLAN Configuration
.
6. Select the Admin Mode Disable or Enable radio button.
This selection specifies the administrative mode for the voice VLAN for the switch. The
default is Disable.
7. Select the interface by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go T
o Interface field and click the Go button.
• T
o configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the heading
row
.
8. From the
Interface Mode menu, select the voice VLAN mode for selected interfaces:
• Disable. This is the default value.
• None
. Allow the IP phone to use its own configuration to send untagged voice traffic.
• VLAN ID
. Configure the phone to send tagged voice traffic. Y
ou must enter the VLAN
ID in the Value field (see the next step).
• Dot1p. Configure voice VLAN 802.1p priority tagging for voice traffic. Y
ou must enter
the dot1p value in the Value field (see the next step).
• Untagged. Configure the phone to send untagged voice traffic.