Programming Program Change Options
70 AFP-200 PN 15511:H2 10/14/2002
3.3 Program Change Options
3.3.1 Overview
This section covers the following Program Change options:
Table 15 Program Change Topics
Topic Refer to
Clear programming
memory
“How to Clear a Program from Memory (0=clr)” on page 73
Autoprogram the control
panel
“How to Autoprogram the Control Panel (1=auto)” on page 73
Program a point for a:
• detector
• monitor module
• control or relay
module
• panel circuit
“How to Program an Intelligent Detector” on page 80
“How to Program a Monitor Module” on page 81
“How to a Program a Control or Relay Module” on page 83
“How to Program a Panel Circuit” on page 84
Change a programming
password (Program
Change or Status
Change)
“How to Change a Programming Password (3=passwd)” on page 85
Create or change the
system message on the
display
“How to Change a System Message (4=message)” on page 86
Create or change a
custom zone label
“How to Change a Zone Label (5=zones)” on page 86
Change the program for
special Zones 90
through 99
“How to Edit a Special Zone (6=spl zones)” on page 87
Change system
functions
“How to Edit System Functions (7=sys)” on page 89
Check the program for
errors
“How to Check the Program (8=check)” on page 92
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
