Notifier AFP-200 - Wiring for Proprietary Security Alarm Applications

Combination Fire/Burglary Applications Installation
158 AFP-200 PN 15511:H2 10/14/2002
4. Plug connector from STS-200 into J11
Figure 148 Typical Installation of an STS-200 Tamper Switch
E.2.3 Wiring for Proprietary Security Alarm Applications
Figure 149 shows typical wiring for proprietary security alarm applications with a
control module configured as a Notification Appliance Circuit. Note the following:
1. The control module is configured as a Notification Appliance Circuit and
programmed in the Protected Premises Unit.
2. Supplementary use only applies to UL-listed systems.
STS-200 wire run
behind CPU board
afp2-sts.cdr
Cabinet
CPU board
JP3
J11
STS-200
Technical Manuals Online! - http://www.tech-man.com