3
Basic copy operations
3-32 d-Color MF25
3.6 Selecting a paper setting
The paper size can be selected automatically according to the document
size or it can be specified manually. Specify the paper size according to the
corresponding procedure, depending on the desired copy settings.
2
Note
If a setting for special paper is selected for a paper tray, that tray is not
selected automatically with the “Auto Paper Select” setting. (However, a
paper tray set to “Single Side Only” is given priority to be selected.) This
setting is useful for paper trays loaded with special paper. For details, re-
fer to “To specify a setting for special paper” on page 7-22.
The default setting is “Auto Paper Select”.
For details on the operations that cannot be combined, refer to “Opera-
tions that cannot be combined” on page 3-6.
The “Auto Zoom” and “Auto Paper Select” settings cannot be selected at
the same time. If the “Auto Zoom” setting was selected, the Zoom screen
appears. In the Zoom screen, specify the desired zoom setting.
Automatically selecting the paper size (“Auto Paper Select” setting)
The size of the loaded document is detected, and copies are produced using
paper of the same size.
If the “×1.0” Zoom setting was specified, paper of the same size as the doc-
ument is selected.
If the zoom ratio was increased or decreased, a paper size that corresponds
to the specified zoom ratio is automatically selected.
1 In the Basic screen, touch [Paper].
The Paper screen appears.
To Next Page
Loading...
Need help?
General