Care of the machine
10
d-Color MF25 10-7
Electrostatic charger wire
If the electrostatic charger wire is dirty, streaks will appear though the printed
images. If this occurs, follow the procedure described below to clean the
electrostatic charger wire.
1 Open the machine’s front door.
2 Slowly pull out the charger-cleaning
tool as far as possible. Next, slowly
push in the charger-cleaning tool as
much as possible. Repeat the above
operations three times.
3 Securely insert each charger-cleaning tool, and then close the front
door.
Print head
If the print head becomes dirty, decreased print quality may result. If this oc-
curs, clean the print head according to the following procedure.
1 Open the machine’s front door.
2 Remove the cleaning tool from the
machine’s front door.
To Next Page
Loading...
Need help?
General