4
Additional copy operations
4-8 d-Color MF25
– If an automatic panel reset operation is performed while the proof
copy for a job is being checked, that job is stored in the memory.
– If the “Auto Reset” parameter is set to “OFF”, the job is added to
the Held Jobs list after no job is performed for one minute.
– To stop the proof copy while scanning or printing, perform the op-
eration described in “Stopping scanning/printing” on page 3-86.
– If multiple copies have been specified, another sample copy can be
printed.
– The number under “# of Sets” in the Change Setting screen is the
number of copies that will be printed when [Print] is touched.
– The number under “# of Sets” in the screen that appeared when a
sample copy is printed indicates the number of copies that are
sample copies/total number of copies specified.
– The number under “Number of Pages” in the screen that appeared
when a sample copy is printed indicates the number of copies that
are sample copies/the number of pages in the sample copy.
8 Touch [Print].
The remaining copies are queued as a copy job.
To Next Page
Loading...
Need help?
General