Troubleshooting
5
d-Color MF25 5-45
If any message other than those listed above appears, perform the operation
described in the message.
Replenish paper. The indicated tray has run out
of paper.
Load paper into the indicated tray.
(See “Loading paper into the 1st
tray” on page 2-45, “Loading paper
into the 2nd, 3rd or 4th tray” on
page 2-50, “Loading paper into the
LCT” on page 2-53, and “Loading
paper into the bypass tray” on
page 2-56.)
Toner cartridge (X) needs
to be replaced soon.
The toner for the indicated
color is about to run out.
Prepare to replace the toner car-
tridge according to your mainte-
nance agreement.
There is no Toner. Since the toner for the indi-
cated color has run out, the
machine is unable to make
copies.
Replace the toner cartridge accord-
ing to your maintenance agreement.
Stapler empty. Replace
Staple Cartridge or can-
cel Staple mode.
The staples have run out. Replace the staple cartridge. See
“Replacing the staples” on
page 9-9.
Misfeed detected. Since a paper misfeed oc-
curred, the machine is unable
to make copies.
Clear the paper misfeed. (See
“When the message “Misfeed de-
tected.” appears” on page 5-6.)
Reinsert the following #
of originals.
After clearing a paper mis-
feed, it is necessary to reload
certain pages of the docu-
ment that have already been
fed through the ADF.
Load the indicated document pages
into the ADF.
Malfunction detected.
Please call your Techni-
cal Representative.
The machine malfunctioned
and is unable to make copies.
Inform your technical representative
of the code displayed on the touch
panel.
Message Cause Remedy
To Next Page
Loading...
Need help?
General